8/16/2023 0 Comments Cuckoo clock mini![]() ![]() Tighten the minute hand nut while holding it still at the 12. The minute hand gets loosened some so you can turn it to the 12 to represent the top of the hour. For example, if there were 6 cuckoos point the hour hand to the six. Put the clock up on the wall and turn the minute hand to make the clock cuckoo out the top of the hour.Ĭount the number of cuckoo’s the clock sounds out and point the hour hand to that number. Putting the hands in a position to point to the right place when it cuckoos the hour. Setting the cuckoo strikeĪfter the install of the cuckoo clock minute hand we need them to point to the right place. The side with the ridge on it will point outward. ![]() The flat side of the hand bushing will go toward the clock dial. Next put the brass bushing with the square hole in it, on the clocks hand shaft arbor’s square portion. Now it’s time to set the hands to point to the correct time when the clock cuckoo’s. This will sandwich the minute hand between the bushing and its nut. Next is the hand nut which goes onto the hand shaft where the threads are on the tip. Put this on the bushing and the ridges will somewhat lock it into place in the hole of the hand. Now put the minute hand on (the longer of the two hands). Do not worry about having it point to the right time yet, we will do that later. So the more you twist the hour hand and push down at the same time, the tighter it will be on the clock. The tube it goes on is tapered although it may not be noticeable. Hour hand is first by a twist and push at the same time, it is only a friction fit. Twist it and pull at the same time and it will come off. Hour hand is next and is only a friction fit. If the bushing is stuck in the hand just remove it by prying up and off with a flat screwdriver. This bushing may or may not come off with the minute hand, in fact it maybe stuck in the hand itself. With the minute hand off it will expose a round bushing that has a square hole in it. ![]() Now you can turn it with your fingers and it will come right off. Turning the hand nut in the counter clockwise direction while holding the hand still, it will loosen up. While holding the minute hand still (longer of the two hands) while loosening the minute hand nut with the pliers. To remove the cuckoo hands will only need a pair of needle nose pliers. Installing the cuckoo clock hands bought from starts with removing the old hands. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |